Launching QSCan in ADMIN Mode
Administrator Access to dartQScan
dartQScan v3
32bit
C:\Program Files\The Plumtree Group\dartQscan3\Qscan.exe /admin
64bit
C:\Program Files (x86)\The Plumtree Group\dartQscan3\Qscan.exe /admin
dartQScan v2
32bit
C:\Program Files\The Plumtree Group\Qscan\Qscan.exe -admin
64bit
There is no 64bit OS that supports Qscan v2.
To launch QScan in “Admin” mode to allow you to configure restricted settings, perform the following steps:
1) Open Start > Run and paste in (without quotation marks, and depending on your Windows version*):
a. XP: “C:\Program Files\Ideagen PLC\dartQSCAN 3\QScan.exe” /admin
b. Windows 7: C:\Program Files (x86)\Ideagen PLC\dartQSCAN 3\QScan.exe /admin
2) Select the project you would like to configure
3) You should now have additional options available, to select the scanner, choose Scanning > Select Scanner and choose the correct model from the list.
a. Please note that the scanner selection is per-project and will need to be set for each. To do this, after the scanner has been set choose File > Change Project and repeat steps 2 & 3 until all projects are set.
*Some older releases of QScan require a different path, if these do not work replace “Ideagen PLC” with “The Plumtree Group” in the path.
This is ONLY a guideline as different versions may have slightly different paths.
To be sure navigate to the folder manually and find the Qscan.exe location